Tone

The TONE tab gathers every tone control in two cards, ordered by where they sit in the chain. PRE-REVERB shapes the signal on its way into the reverb stages; POST-REVERB shapes the output after all of them. The controls belong to three different stages, so each follows that stage’s MIX, BYPASS and SOLO.

PRE-REVERB

These belong to the Source stage and shape the signal before Densification hears it. They are inaudible while the Source MIX is at 0, and they leave the master dry untouched.

Control	Range	What it does
warmth	-6 to +6 dB	Low shelf at 200 Hz. Positive adds body; negative thins the input. EXPERT view.
brightness	-6 to +6 dB	High shelf at 5 kHz. Lifts or tames the high end feeding the reverb. EXPERT view.
presence	-6 to +6 dB	Broadband gain on the source. EXPERT view.

In MINIMAL the Tone macro moves all three.

Densifier EQ

Under [+] DENSIFIER EQ (EXPERT view) are four controls that belong to the Densification stage. top boost and low cut shape what the cascade hears; dry top and dry top Hz shape the source the stage carries through at direct.

Control	Range	Default	What it does
top boost	-12 to +6 dB	+3 dB	High shelf at 5 kHz on the cascade’s input. Lifts the high-frequency content the sparse filters shape.
low cut	20 to 500 Hz	200 Hz	High-pass at 12 dB per octave on the cascade’s input, which keeps the cascade out of the bass. At the default 200 Hz it is about 40 dB down at 20 Hz. No effect while the MULTIBAND bass split is engaged.
dry top Hz	500 Hz to 20 kHz	8 kHz	Corner frequency of the dry top shelf.
dry top	-12 to 0 dB	0 dB	High-shelf cut on the source carried through the stage at direct, so the densified field can take over the top end.

POST-REVERB

This card is the Tone stage.

Control	Range	Default	What it does
tilt	-6 to +6 dB	0 dB	Leans the whole output brighter (positive) or darker (negative). A 31-band, third-octave EQ from 20 Hz to 20 kHz carries it, each band’s gain running in a straight line from -tilt at 20 Hz to +tilt at 20 kHz.

On a multichannel output the tilt acts on every output, the Dry object included.

Getting Started

Interface Guide

Spatial

Features

Reference

Tone

Tone

PRE-REVERB

Densifier EQ

POST-REVERB

​Tone

​PRE-REVERB

​Densifier EQ

​POST-REVERB

Tone

PRE-REVERB

Densifier EQ

POST-REVERB